Place your promotion here

You have no items in your shopping cart.

We are on Holiday from the 11-05-2019 until the 24-05-2019 please note all new orders will be sent on the 25-5-2019

Featured Products

MORSE QUIKSILVER®HEF BANDSAW BLADE 1820 MM (71 21/32")-12.7 MM (1/2")-0.025-6 TPI

MORSE HEF BANDSAW BLADE 1,820 mm ( 71 21/32 " )-12.7 mm ( 1/2" )-0.025-6 TPI MORSE HEF BANDSAW BLADE 1,820 mm ( 71 21/32 " )-12.7 mm ( 1/2" )-0.025-6 TPI

Please Select Options

Be the first to review this product

From From

Availability: In stock

  • Description
  • Additional information




1820 MM (71 21/32")-12.7 MM (1/2")-0.025-6 TPI


Morse Hard Edge Flexback (HEF) band saw blades incorporate a special alloy that offers exceptional fatigue resistance HEF Blades are ideal wood cutting blades suitable for wood production, large workshop and keen hobbyist.




Manufactured in Morse’s advance manufacturing plant in the USA. Featuring annealed welds to prevent brittleness. These industrial standard blades have a minimum gauge of 0.025 mm which increases to 0.042 as the width as the blade increases (unlike inferior quality blades using 0.014 mm), this result in a blade that consistently cuts straighter and for longer due to its hardened tooth tips. 


Features & Benefits


  • These blades are manufactured from a single piece of high carbon steel with individually hardened tooth tips
  • Annealed welds to remove any brittleness and danger of fatigue
  • Flexible back makes them more fatigue resistant
  • Low cost per blade/low cost per cut in wood
  • Can be run at speeds up to 15,000 SFM (surface feet per minute)



Wood Cutting, General Purpose Wood Cutting, Furniture Production, Composition Board, Cork, Plastic,Graphite, Brass, Bronze,  


Additional information

How To Select The Correct TPI


Tooth Selection Guide


Having the correct number of Teeth Per Inch (T.P.I.) is very important!

Too fewer teeth and the teeth will break off, too many and the tooth gullets will become too full, this will:-

1. Reduce the blade life.

2. Cause inaccurate, uneven, rough cuts.

All of which can, again end up being very expensive.


A good guideline is:- A Min of 3, max of 24, ‘sweet spot’ of 6 to 12 teeth in the work piece at any one time.

  1. Be the first to review this product

Write Your Own Review

Your Rating

  1 star 2 stars 3 stars 4 stars 5 stars

Your Review